TO YOUR YACHT
Harness realise system (HRS)
Spinlock still considers a knife to be an essential piece of carried equipment. However, to develop a reliable consistent safety line clip release system. Instead, the company is focused on developing a release system of the actual lifejacket harness. Testing showed that the harness release system needed to be simple to understand, simple to use and simple to maintain as well as reliable over the lifetime of the lifejacket. At the same time, the harness release system must meet the requirements of the ISO12402 approval.
The Spinlock Harness Release System (HRS) is a new innovation which enables the wearer to disconnect from the safety line by releasing a lever behind the soft loop safety line attachment point of the lifejacket harness.
Staying connected to the boat is undoubtedly safer than being in the water and use of a safety line is actively encouraged. However, in the event of a fall overboard, a casualty can find themselves being dragged/trapped alongside or behind the vessel. A situation which can be hard to be released from.
• Activation handle located behind the soft loop, easy to locate, grab and pull
• Soft loop attachment released and open
• User separated from safety line and boat
• Easily reset to use again
The Deckvest 6D is approved to the following international standards:
ISO12402-3 170N Lifejacket
ISO12402-2 275N Lifejacket
ISO12401 Deck Harness
User weight 50kg +
Size Range: 60-150cm
33g CO2 cylinder Product weight: 1.3kg
UML Pro Sensor ELITE inflator
The Pro Sensor Elite® Automatic Inflator replaces the Pro Sensor® Automatic Inflator late in 2018 (13mm shorter and 4 grams lighter than the original Pro Sensor® Automatic Inflator).
This is a water sensitive activation system, that uses a compressed paper capsule which dissolves when wet, which then releases a spring to puncture the CO2 cylinder.
The cap is designed so that only water flowing upwards through the unit will cause it to activate. Water, spray and rain running down the jacket will not cause activation.
The Pro Sensor ELITE has two indicators that show the status of the CO2 cylinder and firing head.